AFCEN Z 12 CN 13 Stainless steels
Data updates
This material has 45 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
AFCEN Z 12 CN 13 Chemical Composition
M 3205: RCC-M II: 2024 / Grade Z 12 CN 13 martensitic stainless steel forgings used for internal hold down springs
Looking for full material performance data?
Free registration required • Instant access
AFCEN Z 12 CN 13 Physical Properties
Temperature
This material has 45 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
AFCEN Z 12 CN 13 Heat Treatments
- Heat treatment shall consist of air, oil, or water + polymer quenching with an austenitizing temperature between 960°C and 1010°C, followed by tempering for 4 hours minimum at a nominal temperature of between 610°C and 670°C and then air cooling.
In addition, the springs may be subjected to stabilizing heat treatment. In this case, the stabilizing heat treatment shall be performed at a temperature 30°C to 50°C less than the minimum tempering temperature.
AFCEN Z 12 CN 13 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
AFCEN Z 12 CN 13 International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 11Composition
- 29Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers