MS X11CrNiMnN19-8-6 Stainless steels
Data updates
This material has 166 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MS X11CrNiMnN19-8-6 Chemical Composition
MS 2317: 2010 / Stainless steels - Chemical Composition
Looking for full material performance data?
Free registration required • Instant access
MS X11CrNiMnN19-8-6 Physical Properties
Temperature
This material has 166 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MS X11CrNiMnN19-8-6 Heat Treatments
- Hot forming (air cooling): 1150-850°C; Solution annealing (water or rapid cooling with air): 1000-1100°C. If heat treatment is carried out in continuous furnace, the upper part of the range specified is usually preferred, or even exceeded. The lower end of the range specified for solution annealing should be aimed at for heat treatment that is part of further processing, otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1 000°C for steels with Mo contents up to 3% and a temperature of 1 020°C for steels with Mo contents exceeding 3%.
- Hot forming (air cooling): 1150-850°C; Solution annealing (water or rapid cooling with air): 1000-1100°C.The lower end of the range specified for solution annealing should be aimed at for heat treatment as part of further processing, because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels; a temperature of 1 000°C for steels with Mo contents up to 3%; a temperature of 1 020°C for steels with Mo contents exceeding 3%.
MS X11CrNiMnN19-8-6 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MS X11CrNiMnN19-8-6 International Equivalent Materials
Showing 15 of 53 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 53 international equivalents?
See all 53 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 53Cross References
- 32Composition
- 32Mechanical Properties
- 4Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 42Total Suppliers