VdTÜV WStE 420 Structural and constructional steels
Data updates
This material has 314 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
VdTÜV WStE 420 Chemical Composition
WB 356/1: 2014 / Weldable fine-grain structural steels with a minimum yield point of 420 MPa sheet, strip, wide flat steel, section and bar steel
Looking for full material performance data?
Free registration required • Instant access
VdTÜV WStE 420 Physical Properties
Temperature
This material has 314 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
VdTÜV WStE 420 Heat Treatments
- The expedient for normalizing temperatures depend on the chemical composition of the steel. The temperature may be different depending on the manufacturer even when the same type of steel, but is generally in the range from 880 to 960°C. The stress relief is performed in the temperature range between 530°C and 580°C. The holding period totals (even if several operations) more than 150 min. For a holding period over 90 min is the lower limit of desirable temperature range.
VdTÜV WStE 420 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
VdTÜV WStE 420 International Equivalent Materials
Showing 15 of 109 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 109 international equivalents?
See all 109 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 109Cross References
- 24Composition
- 132Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 45Total Suppliers