SAE 5349 Type II Stainless steels
Data updates
This material has 42 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE 5349 Type II Chemical Composition
SAE AMS 5349F: 2019 / Steel, Corrosion-Resistant, Investment Castings 13Cr Free Machining; Hardened and Tempered
Looking for full material performance data?
Free registration required • Instant access
SAE 5349 Type II Physical Properties
Temperature
This material has 42 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE 5349 Type II Heat Treatments
- Hardening:
Heat to 1750°F ± 10°F (954°C ± 6°C), hold at heat for 60 min/in (25 mm) of maximum cross section but not less than 30 minutes, and cool at a rate equivalent to air cool.
Hardening and Tempering:
Heat to 1750°F ± 10°F (954°C ± 6°C), hold at heat for 30 minutes ± 3 minutes, and cool at a rate equivalent to still air cool. Heat to 1350°F ± 15°F (732°C ± 8°C), hold at heat for 60 min/in (25 mm) of maximum cross section but not less than 1 hour, and cool in air or inert gas.
SAE 5349 Type II Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE 5349 Type II International Equivalent Materials
Showing 3 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 13Composition
- 5Mechanical Properties
- 19Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers