B.S. 1.5805 Structural and constructional steels
Data updates
This material has 157 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
B.S. 1.5805 Chemical Composition
EN 10084: 2008 / Case hardening steels - Technical delivery conditions
Looking for full material performance data?
Free registration required • Instant access
B.S. 1.5805 Physical Properties
Temperature
This material has 157 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
B.S. 1.5805 Heat Treatments
- End quench test: Quench from 880°C. Carburizing: 875 to 925°C; NOTE: If steels are direct hardened, in general, a carburizing temperature of 950°C is not exceeded. For special procedures, for example under vacuum, higher temperatures (for example 1020 to 1050°C) are not unusual. Core hardening: 830 to 860°C; Case hardening: 780 to 810°C; Tempering: 150 to 200°C (as a guide, for 1 hour minimum).
B.S. 1.5805 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
B.S. 1.5805 International Equivalent Materials
Showing 15 of 55 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 55 international equivalents?
See all 55 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 55Cross References
- 16Composition
- 21Mechanical Properties
- 3Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- 5Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 53Total Suppliers