PROPRIETARY Uddeholm Vanadis 30 SuperClean Tool steels
Data updates
This material has 48 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 30 SuperClean Chemical Composition
Uddeholms AB, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 30 SuperClean Physical Properties
Temperature
This material has 48 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 30 SuperClean Heat Treatments
- Soft annealing:
Protect the steel and heat through to 850-900°C (1560-1650°F). Then cool in the furnace at 10°C/h (20°F/h) to 700°C (1290°F), then freely in air;
Stress relieving:
After rough machining the tool should be heated through to 600-700°C (1110-1290°F), holding time 2 hours. Cool slowly to 500°C (930°F), then freely in air;
Hardening:
Pre-heating temperature: 450-500°C (840-930°F) and 850-900°C (1560-1650°F).
Austenitizing temperature: 1050-1180°C (1920-2160°F), according to the desired final hardness. The tool should be protected against decarburization and oxidation during hardening;
Quenching media:
Martempering bath at approx. 540°C (1000°F), Vacuum furnace with high speed gas at sufficient overpressure (≥ 2 bar);
Tempering:
It should always be carried out at 560°C (1040°F) irrespective of the austenitizing temperature. Temper three times for one hour at full temperature. The tool should be cooled to room temperature between the tempers. The retained austenite content will be less than 1% after this tempering cycle. - Austenitizing temperature 1180°C (2160°F).
PROPRIETARY Uddeholm Vanadis 30 SuperClean Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Uddeholm Vanadis 30 SuperClean International Equivalent Materials
Showing 1 of 12 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 12 international equivalents?
See all 12 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 12Cross References
- 6Composition
- 2Mechanical Properties
- 21Physical Properties
- 2Heat Treatment
- -Metallography
- 1Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers