PROPRIETARY Uddeholm Corrax Stainless steels
Data updates
This material has 39 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Corrax Chemical Composition
Uddeholms AB, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Uddeholm Corrax Physical Properties
Temperature
This material has 39 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Uddeholm Corrax Heat Treatments
- It is delivered in solution treated condition and can be used in the as-delivered condition. When, however, the steel is to be heat treated to a higher hardness, the following instructions may be helpful.
Stress relieving: It can not be performed as for other steel grades since an increase in temperature results in a higher hardness because of ageing effect;
Ageing: Higher hardness is obtained by ageing. When the ageing time is reached, cool the tool in air to room temperature. Ageing at high temperature gives a better toughness compared with ageing to the same hardness at a lower temperature. (Ageing recommendation: At 525°C/4 h - 49–52 HRC, at 575°C/4 h - 44–47 HRC, at 600°C/4 h - 40–43 HRC; Ageing 49–52 HRC is only recommended when toughness is not important.) If the material used at temperatures higher than 200°C the solution treated condition (delivery condition) is not recommended because ageing can occur during use;
Solution treatment: It is possible to solution treat material, if aged, in order to get back to the delivery condition. Solution treatment should be done at 850°C (1560°F), holding time 30 minutes. Cool in air.
PROPRIETARY Uddeholm Corrax Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Uddeholm Corrax International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 7Composition
- 12Mechanical Properties
- 11Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 6Total Suppliers