PROPRIETARY BÖHLER S200 Tool steels
Data updates
This material has 151 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER S200 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER S200 Physical Properties
Temperature
This material has 151 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER S200 Heat Treatments
- Annealing: 770-840°C (1418-1544°F); Controlled slow cooling in furnace (10 to 20°C/h / (18 to 36°F/h) to approx. 600°C (1112°F), air cooling.
Stress relieving: 600-650°C (1112-1202°F); Slow cooling in furnace. To relieve stresses set up by extensive machining or in tools of intricate shape. After through heating, hold in neutral atmosphere for 1 to 2 hours.
Hardening and tempering: 1250-1290°C (2282-2354°F), salt bath, vacuum Preheating: 1st stage ~ 500°C (930°F), 2nd stage ~ 850°C (1560°F), 3rd stage ~1050°C (1920°F) Austenitising: 1250-1290°C (2280-2350°F), holding time after complete heating 80 seconds, maximum 150 seconds, to avoid material damage due to overheating. Quenching: oil, warm bath (500-550°C (930-1020°F)), vacuum (nitrogen).
550-580°C (1022-1076°F), slow heating to tempering temperature immediately after austenitising. Dwell time in the furnace 1 hour per 20 mm material thickness (at least 1 hour) Slow cooling to room temperature 3 tempering cycles recommended.
PROPRIETARY BÖHLER S200 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER S200 International Equivalent Materials
Showing 15 of 64 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 64 international equivalents?
See all 64 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 64Cross References
- 6Composition
- 7Mechanical Properties
- 16Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 56Total Suppliers