PROPRIETARY BÖHLER K600 Tool steels
Data updates
This material has 162 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K600 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER K600 Physical Properties
Temperature
This material has 162 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K600 Heat Treatments
- Annealing: 610-650°C (1130-1202°F); Slow controlled cooling in furnace at a rate of 10 to 20°C/hr (18 to 36°F/hr) down to approx. 600°C (1112°F), further cooling in air.
Stress relieving: 650°C (1202°F); Slow cooling in furnace; intended to relieve stresses set up by extensive machining, or in complex shapes. After through heating, hold in neutral atmosphere for 1 to 2 hours.
Hardening and tempering: 840-870°C (1544-1598°F); Oil, salt bath 300-400°C (572-752°F) air. Holding time after temperature equalization: 15 to 30 minutes. After hardening, tempering to the desired working hardness, see tempering chart.
PROPRIETARY BÖHLER K600 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER K600 International Equivalent Materials
Showing 15 of 69 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 69 international equivalents?
See all 69 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 69Cross References
- 6Composition
- 6Mechanical Properties
- 14Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 63Total Suppliers