PROPRIETARY BÖHLER K306 Tool steels
Data updates
This material has 47 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K306 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER K306 Physical Properties
Temperature
This material has 47 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K306 Heat Treatments
- Annealing: 750-800°C (1382-1472°F); slow controlled cooling in furnace at a rate of 10 to 20°C/hr (18 to 36°F/hr) down to approx. 600°C (1112°F), further cooling in air.
Stress relieving: 650°C (1202°F); slow cooling in furnace; intended to relieve stresses set up by extensive machining, or in complex shapes; after through heating, hold in neutral atmosphere for 1-2 hours.
Hardening and tempering: 1050-1100°C (1922-2012°F); oil, salt bath 500 - 550°C (932 to 1022°F),air; holding time after temperature equalization: 15 to 30 minutes; after hardening, tempering to the desired working hardness, see tempering chart.
PROPRIETARY BÖHLER K306 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER K306 International Equivalent Materials
Showing 6 of 9 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 9 international equivalents?
See all 9 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 9Cross References
- 6Composition
- 7Mechanical Properties
- 14Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 8Total Suppliers