PROPRIETARY BÖHLER K107 Tool steels
Data updates
This material has 143 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K107 Chemical Composition
Böhler Edelstahl, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY BÖHLER K107 Physical Properties
Temperature
This material has 143 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY BÖHLER K107 Heat Treatments
- Annealed: 800-850°C (1472-1562°F), slow controlled cooling in furnace at a rate of 10-20°C/h (18 - 36°F/hr) down to approx. 600°C (1112°F), further cooling in air.
Stress relieved: 650-700°C (1202-1292°F), slow cooling in furnace. Intended to relieve stresses set up by extensive machining, or in complex shapes. After through heating, hold in neutral atmosphere for 1-2 hours.
Hardened and tempered: 950-980°C (1742-1796°F), Oil, salt bath 220 to 250°C or 500 to 550°C (428 to 482°F or 932 to 1022°F), gas, air; Tools of intricate shape or with sharp edges should preferably be hardened in air or salt bath. Holding time after temperature equalization: 15 to 30 minutes. After hardening, tempering to the desired working hardness according to the tempering chart.
PROPRIETARY BÖHLER K107 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY BÖHLER K107 International Equivalent Materials
Showing 15 of 58 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 58 international equivalents?
See all 58 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 58Cross References
- 5Composition
- 7Mechanical Properties
- 15Physical Properties
- 4Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 54Total Suppliers