ASTM A 269 TP304L Stainless steels
Data updates
This material has 2874 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 269 TP304L Chemical Composition
A269/A269M: 2025 / Standard Specification for Seamless and Welded Austenitic Stainless Steel Tubing for General Service
Looking for full material performance data?
Free registration required • Instant access
ASTM A 269 TP304L Physical Properties
Temperature
This material has 2874 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 269 TP304L Heat Treatments
- Solution heat treated: Heating to a minimum austenitizing temperature of 1040°C (1900°F) and quenching in water or rapidly cooling by other means. Alternatively, for seamless tubes, immediately following hot forming while the temperature of the tubes is not less than the specified minimum solution treatment temperature, tubes may be individually quenched in water or rapidly cooled by other means.
When stress-relieved tubes are specified, tubes shall be given a heat treatment at 845-900°C (1550-1650°F) after roll straightening. Cooling from this temperature range may be either in air or by slow cooling. No mechanical straightening is permitted after the stress-relief treatment.
ASTM A 269 TP304L Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM A 269 TP304L International Equivalent Materials
Showing 15 of 813 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 813 international equivalents?
See all 813 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 813Cross References
- 7Composition
- 3Mechanical Properties
- 28Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 205Joints
- -Coatings
- 55Dimensions
- -Tribology
- 1238Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 524Total Suppliers