ASME SA-543 Type C Class 3 Structural and constructional steels
Data updates
This material has 183 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SA-543 Type C Class 3 Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part A Ferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SA-543 Type C Class 3 Physical Properties
Temperature
This material has 183 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SA-543 Type C Class 3 Heat Treatments
- All plates shall be heat treated by heating to a suitable austenitizing temperature, holding for a sufficient period of time to attain uniform temperature throughout the thickness, and quenching in a suitable liquid medium by spraying or immersion. The plates shall then be tempered to produce the required properties by heating to a suitable temperature not lower than 595°C (1100°F) with a holding time of not less than 1.2 min/mm of thickness but not less than 0.5 hour.
Plates over 100 mm in thickness shall receive a prior heat treatment of normalizing at, or water quenching from, a temperature within the range from 900 to 1010°C (1650 to 1850°F) before final heat treatment.
ASME SA-543 Type C Class 3 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SA-543 Type C Class 3 International Equivalent Materials
Showing 10 of 10 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 10 international equivalents?
See all 10 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 10Cross References
- 8Composition
- 38Mechanical Properties
- 52Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- 33Creep
- -Joints
- -Coatings
- 34Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 6Total Suppliers