ASME SA-234 Grade WP11 CL1 Structural and constructional steels
Data updates
This material has 256 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SA-234 Grade WP11 CL1 Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part A Ferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SA-234 Grade WP11 CL1 Physical Properties
Temperature
This material has 256 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SA-234 Grade WP11 CL1 Heat Treatments
- Fittings, after forming at an elevated temperature, shall be cooled to a temperature below the critical range under suitable conditions to prevent injurious defects caused by too rapid cooling, but in no case more rapidly than the cooling rate in still air.
Grade shall be furnished in the annealed, isothermal-annealed, or normalized and tempered condition.
If normalized and tempered, the tempering temperature shall not be less than 620°C (1150°F).
Liquid quenching followed by tempering shall be permitted when approved by the purchaser.
ASME SA-234 Grade WP11 CL1 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SA-234 Grade WP11 CL1 International Equivalent Materials
Showing 10 of 24 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 24 international equivalents?
See all 24 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 24Cross References
- 7Composition
- 43Mechanical Properties
- 83Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- 74Creep
- -Joints
- -Coatings
- 13Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 9Total Suppliers