UNI C 10 Structural and constructional steels
Data updates
This material has 915 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI C 10 Chemical Composition
UNI 6403: 1986 / Seamless steel tubes, intended and not intended for heat treatment, for use in road vehicles and for specific purposes
Looking for full material performance data?
Free registration required • Instant access
UNI C 10 Physical Properties
Temperature
This material has 915 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI C 10 Heat Treatments
- Hot worked at 1150-900°C; Cementation at 890-930°C; Core hardened at 890-920°C; Surface hardened at 780-820°C. Quenched in water; Stress relieved at 150-200°C.
- Material is normally supplied in the hot rolled condition but subject to agreement may be supplied in one of the following conditions: Spheroidise Annealed (Spheroidised). Normalised. The H + T values shown in the mechanical properties table are obtained from an 11mm test bar hardened by water quenching from 900°C +/- 10°C after holding at temperature for at least 30 minutes, and tempered at 180°C +/- 10°C for at least 1 hour. Final Heat Treatment: Case harden at 890 - 930°C. Harden the core by water quenching from 890 - 920°C. Harden the case by water quenching from 780 - 820°C. Finally, temper at 150 - 200°C.
UNI C 10 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI C 10 International Equivalent Materials
Showing 15 of 425 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 425 international equivalents?
See all 425 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 425Cross References
- 32Composition
- 121Mechanical Properties
- 3Physical Properties
- 6Heat Treatment
- 6Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 322Total Suppliers