EN X8CrNiS18-9 Stainless steels
Data updates
This material has 690 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
EN X8CrNiS18-9 Chemical Composition
EN 10088-1: 2023 / Stainless steels - Part 1: List of stainless steels
Looking for full material performance data?
Free registration required • Instant access
EN X8CrNiS18-9 Physical Properties
Temperature
This material has 690 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
EN X8CrNiS18-9 Heat Treatments
- Hot forming: 1200-900°C, air cooling; Solution annealing (+AT): 1000-1100°C, water or air cooling. If heat treatment is carried out in a continuous furnace, the upper part of the range specified should usually be preferred, or even exceeded. The lower end of the range specified for solution annealing should be aimed at the heat treatment as part of further processing, because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as lower limit for Mo-free steels.
- Hot forming: 1150-850°C, air cooling.
AT - Solution annealing: 1000-1100°C, air or water cooling.
EN X8CrNiS18-9 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
EN X8CrNiS18-9 International Equivalent Materials
Showing 15 of 219 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 219 international equivalents?
See all 219 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 219Cross References
- 54Composition
- 98Mechanical Properties
- 77Physical Properties
- 4Heat Treatment
- 1Metallography
- 1Machinability
- 19Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 4Dimensions
- -Tribology
- 1Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 212Total Suppliers