DIN X 5 CrNiMo 17 13 3 Stainless steels
Data updates
This material has 1497 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN X 5 CrNiMo 17 13 3 Chemical Composition
DIN 17455: 1985 / Welded circular tubes of stainless steels for general requirements; technical delivery conditions
Looking for full material performance data?
Free registration required • Instant access
DIN X 5 CrNiMo 17 13 3 Physical Properties
Temperature
This material has 1497 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN X 5 CrNiMo 17 13 3 Heat Treatments
- Recrystallization or solution heat treated at 1020 - 1100°C, air or water cooling. If heat treatment is used in processing the tubes, the lower end of the temperature range should be aimed for. If the subsequent hot working temperature does not fall below 850°C, or if the product has been cold worked, the temperature for any renewed solution heat treatment may drop by -253,15°C (20°K) below the lower limit given here.
Hot working at 1150°C to 750°C, air cooling. Sufficiently rapid cooling required. - Solution annealing during fabrication and further processing at 1020 - 1100°C, quenching in water or sufficiently rapid air cooling. Hot working at 1150 - 750°C, air cooling. If hot working has been carried out at a temperature of at least 850°C or if the product has been cold worked, the temperature of renewed solution annealing may be 20°C less than the lower limit for solution annealing.
DIN X 5 CrNiMo 17 13 3 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN X 5 CrNiMo 17 13 3 International Equivalent Materials
Showing 15 of 734 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 734 international equivalents?
See all 734 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 734Cross References
- 32Composition
- 108Mechanical Properties
- 3Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 92Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 525Total Suppliers