DIN 1.2714 Tool steels
Data updates
This material has 339 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN 1.2714 Chemical Composition
EN ISO 4957: 2018 / Tool steels
Looking for full material performance data?
Free registration required • Instant access
DIN 1.2714 Physical Properties
Temperature
This material has 339 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN 1.2714 Heat Treatments
- Soft annealing: Slowly heated at 650-700°C, held for several hours, slowly cooled, preferably in the furnace.
The soft annealing is most appropriate for machining and cold working and provides the most favorable initial structure for tool hardening.
Hardening: Heated at:
860-900°C, held for 15-30 minutes, air cooled.
830-870°C, held for 15-30 minutes, oil quenched.
Stress relief annealing: Slowly heated 650°C, held for 1-2 hours, slowly cooled in the furnace.
Steel is nitrided in salt baths, gas or powder. The nitriding layer thickness may be 0.01-0.3 mm depending on necessity and method and is usually 0.1 mm. - Austenitized at 850 +/- 10°C and oil quenched (usual quenching media for tools are air, gas or salt bath).
Tempered at 500 +/- 10°C.
DIN 1.2714 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN 1.2714 International Equivalent Materials
Showing 15 of 113 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 113 international equivalents?
See all 113 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 113Cross References
- 25Composition
- 20Mechanical Properties
- 34Physical Properties
- 16Heat Treatment
- 3Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 6Joints
- -Coatings
- 9Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 113Total Suppliers