DIN 1.1338 Structural and constructional steels
Data updates
This material has 158 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN 1.1338 Chemical Composition
WB 453: 2011 / Carbon forged steel C 22.8 S1; Material No 1.1338, bars, forgings
Looking for full material performance data?
Free registration required • Instant access
DIN 1.1338 Physical Properties
Temperature
This material has 158 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN 1.1338 Heat Treatments
- Normalization at 880 to 920°C, cooling in stationary air after the temperature has been reached over the entire cross section; Austenitization at 870 to 910°C, cooling in water; Tempering at 640 to 660°C; Stress-relief annealing at 530 to 600°C. For multiple stress-relief annealing steps, the indicated temperature range shall be applicable for the last stress-relief annealing step. Preceding stress-relief annealing steps can be performed at 530°C to 570°C.
- Quenched and tempered - Hardened: 870 to 910°C, after reaching the temperature in the entire cross-section, water cooling, Tempered: 640 to 660°C, cooling in still air; Normalized: 880 to 920°C, after reaching the temperature in the entire cross-section, cooling in still air; Stress relieved: 520 to 600°C, cooling in still air.
DIN 1.1338 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN 1.1338 International Equivalent Materials
Showing 4 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 18Composition
- 100Mechanical Properties
- 23Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 6Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 1Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers