PROPRIETARY WM H-10 工具钢
材料组别:
黑色金属 / 工具钢
国家与地区/标准:
PROPRIETARY
数据更新
最新更新: 2018-06
更新总数: 1
更新历史
PROPRIETARY WM H-10 化学成分
化学元素
数值
单位
CAS 编号
Ellwood Specialty Steel, Product Data Sheets,
需要完整的材料性能数据吗？
查看完整材料数据 ›
需要注册 • 立即访问
需要注册 • 立即访问
PROPRIETARY WM H-10 物理性能
PROPRIETARY WM H-10 热处理
- Forging:Heating for forging must be done slowly and uniformly. Soak through at 1900-2000°F (1038-1093°C), and reheat as often as necessary, stopping work when the temperature drops below 1650°F (899°C). After forging cool slowly in lime, mica, dry ashes or furnace. Should always be annealed after forging.
Annealing:Heat slowly to 1550-1650°F (843-899°C), hold until the entire mass is heated through, and cool slowly in the furnace (40°F (22°C) per hour) to about 1000°F (538°C), after which the cooling rate may be increased. Suitable precautions must be taken to prevent excessive carburization or decarburization.
Strain relieving:When desirable to relieve the strains of machining, heat slowly to 1050-1250°F (566-677°C), allow to equalize, and then cool in still air.
Preheat for hardening:Warm slightly before charging into the preheat furnace, which should be operating at about 1400-1500°F (760-816°C).
Hardening:It is a very deep hardening steel, and although oil quenching may be used where maximum hardness is required, air hardening is recommended for most applications. The use of salt bath or controlled atmosphere furnace is desirable to minimize decarburization, and if not available, pack hardening spent pitch temperature employed is usually in the range of 1800-1900°F (982-1038°C).
Tempering:Tempering practice may vary with size and application, but is usually performed in the temperature range of maximum secondary hardness or higher double tempering is recommended.
PROPRIETARY WM H-10 机械性能
根据您的应用场景优化材料选择 - 预约演示
- -交叉引用
- 6化学成分
- 14机械性能
- 7物理性能
- 1热处理
- -金相组织
- -切削加工性能
- -应力-应变
- -成形性能
- -疲劳
- -断裂
- -爬行
- -焊接接头
- -涂层
- -尺寸
- -摩擦学
- -腐蚀
- -老化
- -耐候性
- -辐照
- 1供应商总数