European standards for designation of aluminum and aluminum alloys, which is submitted to Technical Committee CEN / TC 132 “Aluminum and Aluminum Alloys”, have two basic designation systems: chemical symbol based designation system and numerical designation system. Chemical symbol based designation system is mainly the same for wrought products and castings while numerical system differs for wrought and casting products...
European standards for designation of aluminum and aluminum alloys, which is submitted to Technical Committee CEN / TC 132 "Aluminum and Aluminum Alloys", have two basic designation systems: chemical symbol based designation system and numerical designation system.
Chemical symbol based designation system is mainly the same for wrought products and castings while numerical system differs for wrought and casting products.
European Standard (EN) and International Aluminum Association (UNS) for wrought products use the same numerical designations with the prefix EN or AW.
The standard Aluminum and aluminum alloys - Designation of alloyed aluminum ingots for remelting, master alloys and castings - Part 1: Numerical designation system (EN 1780 - 1:1999) is a revision of Standard EN 1780 - 1:1996. The difference to the former version is that unalloyed aluminum is removed from the scope and provisions dealing with unalloyed are deleted.
This standard is a part of EN 1780 titled "Aluminum and aluminum alloys - Designation of alloyed aluminum ingots for remelting, master alloys and castings", which has three parts:
Part 1: Numerical designation system
Part 2: Chemical symbol based designation system
Part 3: Writing rules for chemical compositions
The numerical designation system for aluminum and aluminum alloys and master alloys consists of prefix letters and five-figure designation.
The designation is constituted successively by:
The prefix letters of alloys for aerospace applications are different from those above and are specified in EN 2032-1.
Aluminum alloys, ingot and castings have the same numerical designation.
The first of the five figures in the designation indicates the major alloying elements as follows:
The second of the five figures in the designation indicates the alloy group:
21XXX : AlCu,
41XXX : AlSiMgTi,
42XXX : AlSi7Mg,
43XXX : AlSi10Mg,
44XXX : AlSi,
45XXX : AlSi5Cu,
46XXX : AlSi9Cu,
47XXX : AlSi(Cu),
48XXX : AlSiCuNiMg,
51XXX : AlMg,
71XXX : AlZnMg.
The third figure is arbitrary. Indicates various alloys inside the given group. Differences in chemical compositions are minimal.
The forth figure is generally 0.
The fifth figure is always 0 except for alloys for aerospace applications.
The first of the five figures in the designation system is the number 9.
The second and third figures represent the atomic number of the main element.
The last two figures are chronological numbers, but for the fifth figure:
CEN (European Committee for Standardization) members are bound to comply with the CEN/CENELEC Internal regulations, which stipulate the conditions for giving the European Standard the status of a national standard without any alteration.
This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies.
Total Materia è la principale piattaforma informativa sui materiali, che fornisce le più ampie informazioni sulle proprietà dei materiali metallici e non metallici e altri dati sui materiali.
Tutte queste informazioni sono disponibili in Total Materia Horizon, lo strumento di informazione e selezione dei materiali per eccellenza, che offre un accesso impareggiabile a oltre 540.000 materiali e a dati di riferimento curati e aggiornati.
Il totale di Materia Horizon comprende: