ASME SB-752 705C Zirconium Alloys
Data updates
This material has 61 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME SB-752 705C Chemical Composition
ASME Boiler and Pressure Vessel Code An International Code Section II - Part B Nonferrous Material Specifications, American Society of Mechanical Engineers, 2025
Looking for full material performance data?
Free registration required • Instant access
ASME SB-752 705C Physical Properties
Temperature
This material has 61 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME SB-752 705C Heat Treatments
- All castings will be supplied in the as-cast condition except when post-weld heat treatment is required. If post-weld heat treatment is required, it shall consist of a stress relief performed at 565 ± 25°C (1050 ± 50°F) for a minimum of 1/2 h at temperature plus an additional 1/2 h at temperature per inch of thickness for section sizes greater than 25 mm. After heat treatment, the castings should be cooled in air or in the furnace to ambient temperature unless otherwise agreed upon between the purchaser and producer.
ASME SB-752 705C Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME SB-752 705C International Equivalent Materials
Showing 3 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 9Composition
- 24Mechanical Properties
- 10Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- 12Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers