DTD 5104A Aluminium Alloys
Data updates
This material has 34 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DTD 5104A Chemical Composition
D.T.D. 5104A: 1971 / Forgings Stock and Forgings of Aluminium - Zinc - Magnesium - Copper - Manganese Alloy (Solution treated, boiling water quenched and duplex precipitation treated to improve stress corrosion resistance) (Zn 5.7, Mg 2.5, Cu 0.5, Mn 0.5)
Looking for full material performance data?
Free registration required • Instant access
DTD 5104A Physical Properties
Temperature
This material has 34 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DTD 5104A Heat Treatments
- The forgings shall be heat treated as follows:
Solution treat by heating at a temperature of 460±10°C and quenching in boiling water.
Precipitation treat in two stages as follows:
Stage I - Heat at a temperature of 135±5°C for not less than 12 hours. Cool in air or raise temperature directly to the ageing temperature required by Stage II.
Stage II - Heat at a temperature of 150±5° for 14 to 18 hours. Cool in air.
DTD 5104A Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DTD 5104A International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 12Composition
- 17Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers