ASTM F3318 AlSi10Mg Aluminium Alloys
Data updates
This material has 213 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM F3318 AlSi10Mg Chemical Composition
F3318: 2018 / Standard for Additive Manufacturing - Finished Part Properties - Specification for AlSi10Mg with Powder Bed Fusion - Laser Beam
Looking for full material performance data?
Free registration required • Instant access
ASTM F3318 AlSi10Mg Heat Treatments
- Condition SR1: Stress relieved or partially annealed in accordance with AMS 2771 except that the temperature shall be 285°C (±14°C), held for 120 min (±15 min) and cooled at a rate equal to air cooling or faster. Condition SR2: Stress relieved or partially annealed in accordance with AMS 2771 except the temperature shall be 190°C (±14°C), held for 120 min (±15 min) and cooled at a rate equal to air cooling or faster. Condition T6: Solution heat treated in accordance with AMS 2771 except the temperature shall be 530°C (±6°C), held for 360 min minimum, quenched in water or glycol as agreed upon by the part supplier and purchaser, and aged at 160°C (±6°C) for 360 min minimum. Condition HIP+T6: Hot isostatically pressed (HIP) under an inert atmosphere at 100 MPa minimum within the range 510°C - 520°C, held at the selected temperature within ±14°C for 180 ± 60 min and cooled under inert atmosphere to below (93°C). HIP shall be followed by Condition T6 processing. Condition NHT: No heat treat required. Parts are supplied in the as-built condition.
ASTM F3318 AlSi10Mg Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM F3318 AlSi10Mg International Equivalent Materials
Showing 15 of 135 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 135 international equivalents?
See all 135 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 135Cross References
- 13Composition
- 15Mechanical Properties
- -Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 49Total Suppliers