SAE Ti-5Al-4V-0.75Mo-0.5Fe Titanium Alloys
Data updates
This material has 82 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE Ti-5Al-4V-0.75Mo-0.5Fe Chemical Composition
SAE AMS 6951B: 2026 / Titanium Alloy, Sheet 5Al-4V-0.75Mo-0.5Fe Annealed
Looking for full material performance data?
Free registration required • Instant access
SAE Ti-5Al-4V-0.75Mo-0.5Fe Physical Properties
Temperature
This material has 82 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE Ti-5Al-4V-0.75Mo-0.5Fe Heat Treatments
- Annealed by heating to a temperature within the range 704 to 788°C (1300 to 1450°F), holding at the selected temperature within ±14°C (±25°F) for a time commensurate with product thickness and the heating equipment and procedure used. After being reheated in air to 718 ± 8°C (1325 ± 15°F), held at heat for 20 ± 2 minutes, cooled at a rate equivalent tom an air cool or slower.
SAE Ti-5Al-4V-0.75Mo-0.5Fe Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE Ti-5Al-4V-0.75Mo-0.5Fe International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 12Composition
- 6Mechanical Properties
- 2Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 59Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers