UNI 3003 Aluminium Alloys
Data updates
This material has 332 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI 3003 Chemical Composition
UNI 9003-1: 1989 / Wrought primary aluminium and aluminium alloys, Aluminium-manganese alloys, Al Mn 12 Cu 012 alloy (3003)
Looking for full material performance data?
Free registration required • Instant access
UNI 3003 Physical Properties
Temperature
This material has 332 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI 3003 Heat Treatments
- Full Annealing from 450 to 500°C for 1 to 3h to scheme with subsequent cooling in ambient air (or in the oven). They can follow operations of flattening, straightening and ironing, for reasons of dimensional tolerances, which have a slight strain hardening.
H12, H14, H16 and H18 - work hardened states provided for rolled and drawn, obtained by performing the material, in an intermediate stage of processing, the complete annealing (O) followed by a final cold processing plastic, extrusion lamination, involving different work hardening equal to about 18% (H12), 37% (H14), 55% (H16) and 75% (H18).
H22, H24, H25, H26 - United recovery (crystalline rearrangement) provided for rolled and / or drawn, obtained by performing on the same semi-finished very hard drawn (H16, H18) a partial annealing from 230 to 260°C for 2 to 6h to hold at followed by cooling in ambient air (H16 ->H24, H22, H18 -> H26, H25, H24).
H112 - Raw extrusion of the hot rolling. They can follow operations of flattening, straightening and ironing, for reasons of dimensional tolerances, which have a slight strain hardening.
UNI 3003 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI 3003 International Equivalent Materials
Showing 15 of 137 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 137 international equivalents?
See all 137 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 137Cross References
- 8Composition
- 83Mechanical Properties
- 22Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 19Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 61Total Suppliers