ASTM A 494 N26055 Nickel Alloys
Data updates
This material has 29 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM A 494 N26055 Chemical Composition
A494/A494M: 2026 / Standard Specification for Castings, Nickel and Nickel Alloy
Looking for full material performance data?
Free registration required • Instant access
ASTM A 494 N26055 Physical Properties
Temperature
This material has 29 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM A 494 N26055 Heat Treatments
- As cast: Load into furnace at 315°C (600°F) maximum. Heat to 870°C (1600°F) and hold for 1 h plus an additional 30 min for each 13 mm of cross section over 25 mm (for cross sections over 125 mm, it may be necessary to increase the hold time if maximum softness is desired). Cool to 705°C (1300°F) [for maximum softness and the least variation in hardness levels, castings should be transferred from an oven at 870°C (1600°F) to a second oven at 705°C (1300°F)] and hold at temperature for 30 min, then quench in oil to room temperature.
ASTM A 494 N26055 International Equivalent Materials
Showing 6 of 10 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 10 international equivalents?
See all 10 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 10Cross References
- 11Composition
- -Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers