PROPRIETARY Sandvik Sanicro 69 Nickel Alloys
Data updates
This material has 211 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Sandvik Sanicro 69 Chemical Composition
Sandvik Materials Technology, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Sandvik Sanicro 69 Physical Properties
Temperature
This material has 211 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Sandvik Sanicro 69 Heat Treatments
- For steam generator application the tubes are delivered in the thermally treated conditions. This means exposure at about 720°C (1330°F) for normally 10 hours. Prior to the thermal treatment the tubes are solution annealed at approximately 1100°C (2010°F) for some minutes.
For other applications the tubes are delivered in the solution annealed condition. If additional solution annealing is necessary after further processing the following procedure is recommended: 1050-1150°C (1920-2100°F), 1-10 minutes, rapid cooling in air or water.
PROPRIETARY Sandvik Sanicro 69 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Sandvik Sanicro 69 International Equivalent Materials
Showing 15 of 87 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 87 international equivalents?
See all 87 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 87Cross References
- 9Composition
- 21Mechanical Properties
- 41Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 51Total Suppliers