UNI P-AlZn5.8MgCu-clad Aluminium Alloys
Data updates
This material has 47 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
UNI P-AlZn5.8MgCu-clad Chemical Composition
UNI SPERIMENTALE 3736: 1956 / Primary wrought aluminium-zinc-magnesium-copper-clad alloy (Zn 5.8%, Mg 2.5%, Cu 1.6%)
Looking for full material performance data?
Free registration required • Instant access
UNI P-AlZn5.8MgCu-clad Physical Properties
Temperature
This material has 47 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
UNI P-AlZn5.8MgCu-clad Heat Treatments
- R: Complete annealing at 370 - 430 °C for 3 - 6 hours with slow cooling in oven (max 20°C/h until 200 °C). TA: Water quenching (10 - 30°C) from 455 - 475°C, after preheating for 0.5 - 2 hours in salt-bath.Artificial ageing at 120 - 130°C for 24 hours. Hot working range: 350 - 420°C
UNI P-AlZn5.8MgCu-clad Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
UNI P-AlZn5.8MgCu-clad International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 13Composition
- 13Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 4Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers