PROPRIETARY Alloy 800H Nickel Alloys
Data updates
This material has 147 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Alloy 800H Chemical Composition
Sandmeyer Steel Company, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Alloy 800H Physical Properties
Temperature
This material has 147 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Alloy 800H Heat Treatments
- Hot Forming: The hot-working temperature range for Alloy 800H and 800HT is 950 – 1200°C if deformation is 5 percent or greater. If the degree of hot deformation is less than 5 percent a hot working temperature range between 850 – 1050°C is recommended. If the hot working metal temperature falls below the minimum working temperature, the piece must be re-heated. The alloys should be water quenched or rapid air cooled through the temperature range of 540 – 760°C. Alloys 800H and 800HT require solution annealing after hot working to ensure optimal creep resistance and properties. Cold Forming: The alloys should be in the annealed condition prior to cold forming.
PROPRIETARY Alloy 800H Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Alloy 800H International Equivalent Materials
Showing 15 of 29 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 28 international equivalents?
See all 28 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 28Cross References
- 19Composition
- 31Mechanical Properties
- 18Physical Properties
- 2Heat Treatment
- 1Metallography
- -Machinability
- 2Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- 28Joints
- -Coatings
- -Dimensions
- -Tribology
- 2Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 16Total Suppliers