SAE Inconel 722 Nickel Alloys
Data updates
This material has 133 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE Inconel 722 Chemical Composition
SAE AMS 5541J: 2024 / Nickel Alloy, Corrosion- and Heat Resistant, Sheet and Strip 73Ni - 15.5Cr - 2.4Ti - 0.7Al - 7.0Fe (Alloy 722) Annealed
Looking for full material performance data?
Free registration required • Instant access
SAE Inconel 722 Physical Properties
Temperature
This material has 133 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE Inconel 722 Heat Treatments
- Annealed by heating to a temperature within the range 954 to 1010°C (1750 to 1850°F), holding at the selected temperature within ±14°C (±25°F) for a time commensurate with section thickness, and cooling rapidly.
Precipitation heat treated by heating to 704°C ± 14°C (1300°F ± 25°F), holding at heat for not less than 16 hours, and cooling in air. - Material condition: 1079°C; 704°C.
SAE Inconel 722 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE Inconel 722 International Equivalent Materials
Showing 4 of 4 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 4 international equivalents?
See all 4 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 4Cross References
- 31Composition
- 32Mechanical Properties
- 16Physical Properties
- 3Heat Treatment
- -Metallography
- 1Machinability
- 5Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- 1Creep
- -Joints
- -Coatings
- 35Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers