DIN 3.7255 Titanium Alloys
Data updates
This material has 4463 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
DIN 3.7255 Chemical Composition
DIN 17861: 1990 / Seamless circular titanium and titanium alloy tubes; technical delivery conditions
Looking for full material performance data?
Free registration required • Instant access
DIN 3.7255 Physical Properties
Temperature
This material has 4463 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
DIN 3.7255 Heat Treatments
- Heat treatment is usually carried out in an oxidic atmosphere in electrical or gas-heated ovens, either using an inert gas or vacuum.
Annealing shall be carried out at temperatures between 650°C and 750°C.
The holding time is 3 min per mm of product thickness but at least 15 min while cooling down in air.
For high degrees of forming or large dimensions, a different holding time can be practical for annealing.
Stress relief heat treatment shall be carried out at 450°C to 600°C. The holding time is at least 30 min while cooling down in air. - Soft annealing is to be carried out at temperatures between 650°C and 750°C. The holding time is 3 min/mm thickness of the product, minimum 15 min air cooling.
Stress relief annealing is to be carried out at temperatures from 450°C to 600°C. The holding time is minimum 30 minutes, air cooling.
DIN 3.7255 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
DIN 3.7255 International Equivalent Materials
Showing 2 of 2 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 2 international equivalents?
See all 2 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 2Cross References
- 27Composition
- 94Mechanical Properties
- 25Physical Properties
- 3Heat Treatment
- -Metallography
- -Machinability
- 8Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 17Dimensions
- -Tribology
- 4283Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 3Total Suppliers