B.S. TA 55 Titanium Alloys
Data updates
This material has 25 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
B.S. TA 55 Chemical Composition
BS TA 55: 1973 / Specification for forgings of titanium-copper alloy (tensile strength 650-880 N/mm2) (limiting ruling section 75 mm)
Looking for full material performance data?
Free registration required • Instant access
B.S. TA 55 Physical Properties
Temperature
This material has 25 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
B.S. TA 55 Heat Treatments
- The forgings and test samples shall be heat treated as follows:
1) Heat uniformly at a temperature between 805°C and 820°C for a time dependent on the cross section, with a minimum of 30 minutes
2) Cool in still air, forced air blast, oil or water, according to the ruling section
It is recommended that, in order to obtain the specified mechanical properties, material of ruling section greater than 25 mm should be cooled by quenching in forced air blast, oil or water.
3) Heat at a temperature of 400°C ± 5°C for not less than 8 hours nor more than 24 hours
4) Heat (with or without intermediate air cooling) at a temperature of 475°C ± 5°C for 8 hours
5) Cool in air
B.S. TA 55 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
B.S. TA 55 International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 4Composition
- 4Mechanical Properties
- 14Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers