SAE D357.0 Aluminium Alloys
Data updates
This material has 73 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE D357.0 Chemical Composition
SAE AMS 4241F: 2026 / Aluminum Alloy Castings 7.0Si - 0.58Mg - 0.15Ti - 0.06Be (D357.0-T6) Solution and Precipitation Heat Treated Dendrite Arm Spacing (DAS) Controlled
Looking for full material performance data?
Free registration required • Instant access
SAE D357.0 Physical Properties
Temperature
This material has 73 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE D357.0 Heat Treatments
- The solution heat treat temperature shall be 543 ± 6°C (1010 ± 10°F). The quenching and precipitation heat treating procedure shall be established to develop the required casting properties.
- Solution heat treatment shall be at the temperature: 543°C (1010°F), minimum soak time is 8 hours and Quenched;
Final solution heat treatment above 543°C (1010°F) may require an intermediate solution heat treatment of 1 hour minimum at 538 to 543°C (1000 to 1010°F) to prevent eutectic melting of magnesium-rich phases during final solution heat treatment.
Temper after Solution treatment shall be T4 and delay at room temperature.
Annealing at 441°C (825°F), minimum soak time is 1 hour; Air cooling;
Aging (precipitation heat treatment):
Condition before Aging W or T4;
Aging at 160°C (320°F), soak time is 2-12 hours;
Temper T6 after Aging.
SAE D357.0 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE D357.0 International Equivalent Materials
Showing 2 of 2 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 2 international equivalents?
See all 2 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 2Cross References
- 18Composition
- 27Mechanical Properties
- 11Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- 8Stress-Strain
- -Formability
- -Fatigue
- 1Fracture
- -Creep
- -Joints
- -Coatings
- 4Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers