SAE A240.0 Aluminium Alloys
Data updates
This material has 31 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SAE A240.0 Chemical Composition
SAE AMS 4227E: 1992 / Aluminum Alloy, Casting, Sand, 8.0Cu 6.0Mg 0.50Mn 0.50Ni, As Cast
Looking for full material performance data?
Free registration required • Instant access
SAE A240.0 Physical Properties
Temperature
This material has 31 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SAE A240.0 Heat Treatments
- Heat treated at 400°F (205°C): heated to 400°F ± 5 (205°C ± 3), held at heat for 10 to 20 minutes before testing, and tested at 400°F ± 5 (205°C ± 3) at a rate not greater than 0.05 inch/inch per minute (0.05 mm/mm per minute) up to the yield strength and at a rate of 0.11 - 0.14 inch/inch per minute (0.11 - 0.14 mm/mm per minute) above the yield strength.
SAE A240.0 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SAE A240.0 International Equivalent Materials
Showing 6 of 11 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 11 international equivalents?
See all 11 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 11Cross References
- 11Composition
- 5Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers