IS X04Cr18Ni12Mo3 Stainless steels
Data updates
This material has 166 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
IS X04Cr18Ni12Mo3 Chemical Composition
IS 6603: 2024 / Stainless Steel Semi-Finished Products, Bars, Wire Rods and Bright Bars - Specification
Looking for full material performance data?
Free registration required • Instant access
IS X04Cr18Ni12Mo3 Physical Properties
Temperature
This material has 166 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
IS X04Cr18Ni12Mo3 Heat Treatments
- Hot forming at 1150-850°C, cooling in air.
Solution annealing (+AT) at 1070-1150°C, rapidly cooling in water or air.
The lower end of the range for solution annealing should be aimed at for heat treatment as part of further processing. Because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1000°C for steels with Mo contents up to 3%; a temperature of 1020°C for steels with Mo contents exceeding 3%. - Solution annealed at 1 020 to 1 120°C - If heat treatment is carried out in a continuous furnace, the upper part of the range specified is usually preferred, or even exceeded;
Cooling in water, air - Cooling sufficiently rapidly in order to avoid the occurrence of intergranular corrosion as defined in IS 10461 (Part 2).
IS X04Cr18Ni12Mo3 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
IS X04Cr18Ni12Mo3 International Equivalent Materials
Showing 15 of 109 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 109 international equivalents?
See all 109 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 109Cross References
- 18Composition
- 23Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 10Total Suppliers