PROPRIETARY H110-30 Magnetic and electrical materials
Data updates
This material has 103 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY H110-30 Physical Properties
Temperature
This material has 103 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY H110-30 Heat Treatments
- Short-time annealing: Laminations are usually subjected to short-time annealing in a roller furnace. This process takes a few minutes and requires a soaking time of 1 to 2 minutes at a maximum temperature of 860°C.
Long-time annealing: Wound cores and stacking transformers undergo long-time annealing in a box-type furnace. Long-time annealing should be carries out under the following conditions: soaking temperature: min. 820°C, max. 840°C to 850°C; soaking time: 2 hours (the coolest part of the material must be at least 800°C); cooling: preferably within the furnace to about 200°C to 300°C; protective atmosphere: preferably 100% nitrogen, addition of hydrogen is not recommended.
PROPRIETARY H110-30 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY H110-30 International Equivalent Materials
Showing 15 of 42 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 42 international equivalents?
See all 42 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 42Cross References
- -Composition
- 10Mechanical Properties
- 8Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 42Total Suppliers