SEW S 6-5-2 Tool steels
Data updates
This material has 464 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
SEW S 6-5-2 Chemical Composition
SEW 320: 1969 / High speed steels
Looking for full material performance data?
Free registration required • Instant access
SEW S 6-5-2 Physical Properties
Temperature
This material has 464 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
SEW S 6-5-2 Heat Treatments
- Soft annealing: Heated slowly at 770-840°C (the upper limit of this temperature range applies to higher alloyed, and the lower limit for lower alloyed high speed steels), held for 2 to 4 hours, slowly cooled in the furnace to 500-600°C, removed from the furnace and placed in a protected place.
Hardening: Heated at 1190-1230°C. The temperature of the hot bath should be 500-550°C and must not exceed 580°C during extended use.
When cooling in oil, at about 40-70°C, the samples should be moved slowly and evenly and should not be left in oil until completely cooled, but when they reach 300-200°C.
Tempering: Heated slowly at 530-560°C, held for 1 to 3 hours, depending on the size of the samples. The tempering takes place in a neutral salt bath or in an air circulation furnace.
SEW S 6-5-2 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
SEW S 6-5-2 International Equivalent Materials
Showing 15 of 214 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 214 international equivalents?
See all 214 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 214Cross References
- 5Composition
- 2Mechanical Properties
- 42Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 8Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 192Total Suppliers