PROPRIETARY Chronifer M-4028 Stainless steels
Data updates
This material has 371 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Chronifer M-4028 Chemical Composition
L. Klein SA, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Chronifer M-4028 Physical Properties
Temperature
This material has 371 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Chronifer M-4028 Heat Treatments
- Forming. Warm: forging: 950 – 1100°C, preferably > 1020°C, slow cooling. Slow heating up 850°C, then faster up to the forging temperature. Cold: Feasible after annealing at 750 – 825°C, slow cooling. Soft anneal: 745 – 825°C, holding time 2 – 4h, furnace cooling 30°C/h to 600°C. Intermediate anneal during cold working: 630 – 680°C. Quenching. Primary quench oil, air or gas: 980 – 1030°C. Option: Secondary quench at sub-zero temperatures -20 up to -80°C/12 – 48h, preferably -80°C/12 – 24h or Cryo treatment: -196°C/6 – 12h, progressive step-by-step cooling to avoid a possible cracking. Tempering according to needs. Not recommended temperature range: 400 – 580°C (brittleness range) because of the increased risk of inter-granular corrosion.
PROPRIETARY Chronifer M-4028 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Chronifer M-4028 International Equivalent Materials
Showing 15 of 225 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 225 international equivalents?
See all 225 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 225Cross References
- 7Composition
- 3Mechanical Properties
- 17Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 118Total Suppliers