GOST X 2 CrNi 18 10 Stainless steels
Data updates
This material has 235 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
GOST X 2 CrNi 18 10 Chemical Composition
GOST ISO 9329-4: 2013 / Seamless tubes from austenitic high-alloy steels for pressure purposes. Specifications
Looking for full material performance data?
Free registration required • Instant access
GOST X 2 CrNi 18 10 Physical Properties
Temperature
This material has 235 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
GOST X 2 CrNi 18 10 Heat Treatments
- Solutionizing: 1000-1100°C, water quench or rapid air cool.
- Solid solution treated at 1000-1100°C, water or air cooled.
When heat treating in a continuous furnace, it is recommended to maintain the furnace temperature close to or above the upper limit of the established range.
If heat treatment of pipes after delivery is expected, it is recommended to use temperatures close to the lower limit of the established range. If during hot deformation the temperature does not fall below the established lower limit, reheating is recommended at the following temperatures: 980°C for steels that do not contain molybdenum; 1000°C for steels with a molybdenum mass fraction equal to or less than 3%; 1020°C for steels with a molybdenum mass fraction greater than 3%.
GOST X 2 CrNi 18 10 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
GOST X 2 CrNi 18 10 International Equivalent Materials
Showing 15 of 140 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 140 international equivalents?
See all 140 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 140Cross References
- 14Composition
- 70Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- 1Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers