MIL S-24093A Type III Class D Structural and constructional steels
Data updates
This material has 18 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MIL S-24093A Type III Class D Chemical Composition
MIL-S-24093A: 1991 / Steel forgings, carbon and alloy heat treated
Looking for full material performance data?
Free registration required • Instant access
MIL S-24093A Type III Class D Physical Properties
Temperature
This material has 18 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MIL S-24093A Type III Class D Heat Treatments
- Class shall be either normalized and tempered or quenched and tempered, in their final heat treated condition. Tempering temperature shall not be below 565°C (1050°F); Stress relieving: At the discretion of the contractor or when specified by the contracting activity a stress relief treatment may be performed on forgings after final machining, in which, case the stress relief temperature shall be at least 10°C (50°F), below the tempering temperature applied to the forging. In cases where weld repairs have been performed after final heat treatment, the need for stress relief shall be judged by the contracting activity.
MIL S-24093A Type III Class D Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MIL S-24093A Type III Class D International Equivalent Materials
Showing 3 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 6Composition
- 5Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- -Total Suppliers