MS ISO 2892/JSA/XNi20Cr2 Cast irons
Data updates
This material has 4549 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MS ISO 2892/JSA/XNi20Cr2 Chemical Composition
MS 2098: 2008 / Austenitic cast irons - Classification
Looking for full material performance data?
Free registration required • Instant access
MS ISO 2892/JSA/XNi20Cr2 Physical Properties
Temperature
This material has 4549 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MS ISO 2892/JSA/XNi20Cr2 Heat Treatments
- The recommended stress-relief heat treatment is as follows: a) heat up to between 625°C and 650°C at a rate not exceeding 150°C/h; b) hold within this temperature range for 2 h plus 1 h, per 25 mm section thickness; c) cool down to 200°C in the furnace, at a rate not exceeding 100°C/h; d) air cool; The recommended high-temperature stabilising (for a static or cyclic elevated temperature service at 500°C or above) heat treatment is as follows: a) heat up to between 875°C and 900°C at a rate not exceeding 150°C/h; b) hold within this temperature range for 2 h plus 1 h, per 25 mm section thickness; c) cool down to 500°C in the furnace, at a rate not exceeding 50°C/h. d) air cool.
MS ISO 2892/JSA/XNi20Cr2 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MS ISO 2892/JSA/XNi20Cr2 International Equivalent Materials
Showing 15 of 93 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 93 international equivalents?
See all 93 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 93Cross References
- 7Composition
- 25Mechanical Properties
- 8Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 3Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- 4348Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 64Total Suppliers