ASTM F879 Group 1-CW1 384 Stainless steels
Data updates
This material has 76 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASTM F879 Group 1-CW1 384 Chemical Composition
F879: 2023 / Standard Specification for Stainless Steel Socket Button, Low and Flat Countersunk Head Cap Screws
Looking for full material performance data?
Free registration required • Instant access
ASTM F879 Group 1-CW1 384 Physical Properties
Temperature
This material has 76 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASTM F879 Group 1-CW1 384 Heat Treatments
- Condition CW1 - shall be annealed by heating to 1040 +/- 10°C (1900 +/- 50°F) to obtain maximum corrosion resistance and minimum permeability. The screws shall be held for a sufficient time at temperature, then cooled at a rate sufficient to prevent precipitation of the carbide, then cold worked to develop specific properties.
ASTM F879 Group 1-CW1 384 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASTM F879 Group 1-CW1 384 International Equivalent Materials
Showing 15 of 50 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 50 international equivalents?
See all 50 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 50Cross References
- 7Composition
- 6Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 5Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 4Total Suppliers