PROPRIETARY Catamold FN08 Structural and constructional steels
Data updates
This material has 58 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Catamold FN08 Chemical Composition
BASF SE, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Catamold FN08 Physical Properties
Temperature
This material has 58 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Catamold FN08 Heat Treatments
- Sintering can be performed in either nitrogen or hydrogen. By sintering in nitrogen the carbon from the powder is kept in the part and the part can be heat treated. If parts are sintered in hydrogen the carbon content is reduced to < 0.1 %; parts can be case hardened or carbonitrided. For both atmospheres dry and clean gases must be used; gas qualities of 4.8 (O2 = 3 vpm, H2O = 35 vpm) or better are recommended. As sintering support alumina plates with a cleanness = 99.6% may be used, e. g. a) sintering in 100 % nitrogen: A typical sintering cycle is: room temperature - 5 K/min – 600 °C, hold 1 h, 600 °C - 5 K/min – 1290 °C, hold 1 h furnace cooling. b) sintering in 100 % hydrogen: A typical sintering cycle is: room temperature - 5 K/min - 600 °C, hold 1 h, 600 °C - 5 K/min – 1290 °C, hold 3 h furnace cooling.
In the early stage of the sintering process remaining binder constituents are burnt off and the pyrolysis products should be removed by a suction fan. Removal of condensed pyrolysis products from the wall of the sintering furnace should be done wearing laboratory gloves or, in extreme cases gloves made of nitrile rubber.
PROPRIETARY Catamold FN08 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Catamold FN08 International Equivalent Materials
Showing 1 of 1 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 1 international equivalents?
See all 1 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 1Cross References
- 3Composition
- 46Mechanical Properties
- 5Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 2Total Suppliers