MIL HY-130 Structural and constructional steels
Data updates
This material has 25 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MIL HY-130 Chemical Composition
MIL-S-24512: 1975 / Steel forgings, alloy, structural, high yield strength (HY-130)
Looking for full material performance data?
Free registration required • Instant access
MIL HY-130 Physical Properties
Temperature
This material has 25 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MIL HY-130 Heat Treatments
- The forgings shall be quenched and tempered. The producer shall determine the detailed procedure for heat treating the forgings to meet the mechanical property requirements with the exception that the final austenitizing temperature shall be specified by the producer and shall not exceed 1650°F(899°C) and the tempering temperature shall be not less than 1000°F(538°C). Forgings shall be water quenched after tempering.
MIL HY-130 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MIL HY-130 International Equivalent Materials
Showing 2 of 3 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 3 international equivalents?
See all 3 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 3Cross References
- 11Composition
- 4Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- 1Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 2Total Suppliers