PROPRIETARY Sandvik Pressurfect Stainless steels
Data updates
This material has 697 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Sandvik Pressurfect Chemical Composition
Sandvik Materials Technology, Product Data Sheets,
Looking for full material performance data?
Free registration required • Instant access
PROPRIETARY Sandvik Pressurfect Physical Properties
Temperature
This material has 697 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
PROPRIETARY Sandvik Pressurfect Heat Treatments
- Annealing after cold bending is not normally necessary, but this point must be decided with regard to the degree of bending and the operating conditions. Heat treatment, if any, should take the form of stress relieving at 850-950°C (1560-1740°F), cooling in air, or solution annealing at 1000-1100°C (1830-2010°F), and rapid cooling in air or water. Hot bending is carried out at 1100-850°C (2010-1560°F) and should be followed by solution annealing.
PROPRIETARY Sandvik Pressurfect Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
PROPRIETARY Sandvik Pressurfect International Equivalent Materials
Showing 15 of 438 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 438 international equivalents?
See all 438 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 438Cross References
- 7Composition
- 8Mechanical Properties
- 15Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- 1Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 227Total Suppliers