VdTÜV C 22.8 Structural and constructional steels
Data updates
This material has 604 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
VdTÜV C 22.8 Chemical Composition
WB 350/1: 2000 / Heat-resistant carbon steel, C 22.8, WN 1.0460
Looking for full material performance data?
Free registration required • Instant access
VdTÜV C 22.8 Physical Properties
Temperature
This material has 604 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
VdTÜV C 22.8 Heat Treatments
- Normalizing from 880-910°C, after reaching the temperature in the entire cross-section, cooling in still air
Stress relieving from 520-580°C.
Heat through and hold within the temperature range from 520-580°C.
Fot t <= 15mm (min.15min), for 15 < t <= 30mm (min.30min), for t > 30mm (approx.60min). For subsequent annealing, the lower limit of the temperature range should be aimed for. Cooling in still air. - Annealing at 880-940°C and cooling in still air; Stress relieving at 520 to 600 °C (soaking and retention within this temperature range), where for t <= 15mm, duration time is minimum 15 minutes, for 15 < t <= 30 mm, duration time is minimum 30 minutes and for t > 30 mm, duration time is approx. 60 minutes. Cooling in still air.
VdTÜV C 22.8 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
VdTÜV C 22.8 International Equivalent Materials
Showing 15 of 270 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 270 international equivalents?
See all 270 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 270Cross References
- 14Composition
- 104Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 1Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 210Total Suppliers