MIL Class 1 Structural and constructional steels
Data updates
This material has 99 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
MIL Class 1 Chemical Composition
MIL-DTL-12560K: 2013 / Armor plate, steel, wrought, homogeneous (for use in combat-vehicles and for ammunition testing)
Looking for full material performance data?
Free registration required • Instant access
MIL Class 1 Physical Properties
Temperature
This material has 99 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
MIL Class 1 Heat Treatments
- The austenitizing temperature for production plates may vary within a range of 50° above the temperature used for test plates, but in no case shall the plate surface exceed 1800°F (982°C). Stress relieving the plates, local or general, shall be allowed after final quenching and tempering at a maximum temperature of 50°F (10°C) below the tempering temperature. Plates shall not be stress relieved in a temperature range of 500-700°F(260-371°C). After stress relieving, the plates shall be tested for hardness.
MIL Class 1 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
MIL Class 1 International Equivalent Materials
Showing 5 of 8 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 8 international equivalents?
See all 8 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 8Cross References
- 65Composition
- 12Mechanical Properties
- 3Physical Properties
- 1Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 4Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 6Total Suppliers