ASME 1.4371 Stainless steels
Data updates
This material has 223 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME 1.4371 Chemical Composition
Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes, EN 10088-2, 2014
Looking for full material performance data?
Free registration required • Instant access
ASME 1.4371 Physical Properties
Temperature
This material has 223 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME 1.4371 Heat Treatments
- Hot forming at 1150 to 850°C, air cooling
Solution annealing (+AT) at 1000 to 1100°C, air or water cooling. Cooling sufficiently rapidly in order to avoid the occurrence of intergranular corrosion.
Solution annealing may be omitted if the conditions for hot working and subsequent cooling are such that the requirements for the mechanical properties of the product and the resistance to intergranular corrosion. If heat treatment is carried out in a continuous furnace, the upper part of the range specified is usually preferred, or even exceeded. Lower end of the range specified for solution annealing should be aimed at the heat treatment as part of further processing, because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1000°C for steels with Mo contents up to 3% and a temperature of 1020°C for steels with Mo contents exceeding 3%. - Hot forming: 1150 to 850°C, air cooling; Solution annealing (+AT): 1000 to 1100°C, water or air cooling.
ASME 1.4371 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME 1.4371 International Equivalent Materials
Showing 15 of 58 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 58 international equivalents?
See all 58 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 58Cross References
- 17Composition
- 77Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- 19Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 47Total Suppliers