ASME X1CrNiMoCuN24-22-8 Stainless steels
Data updates
This material has 204 properties — only a subset is shown here.
Unlock full material properties, including detailed values across temperatures and conditions.
Free registration required • Instant access
ASME X1CrNiMoCuN24-22-8 Chemical Composition
Stainless steels - Part 2: Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general purposes, EN 10088-2, 2014
Looking for full material performance data?
Free registration required • Instant access
ASME X1CrNiMoCuN24-22-8 Physical Properties
Temperature
This material has 204 properties — only a subset is shown here.
Unlock detailed physical values across temperatures and conditions.
Free registration required • Instant access
ASME X1CrNiMoCuN24-22-8 Heat Treatments
- Hot forming at 1200 to 1000°C, air cooling
Solution annealing (+AT) at 1150 to 1200°C, air or water cooling. Cooling sufficiently rapidly in order to avoid the occurrence of intergranular corrosion.
Solution annealing may be omitted if the conditions for hot working and subsequent cooling are such that the requirements for the mechanical properties of the product and the resistance to intergranular corrosion. If heat treatment is carried out in a continuous furnace, the upper part of the range specified is usually preferred, or even exceeded. Lower end of the range specified for solution annealing should be aimed at the heat treatment as part of further processing, because otherwise the mechanical properties might be affected. If the temperature of hot forming does not drop below the lower temperature for solution annealing, a temperature of 980°C is adequate as a lower limit for Mo-free steels, a temperature of 1000°C for steels with Mo contents up to 3% and a temperature of 1020°C for steels with Mo contents exceeding 3%. - Hot working (air cooling): 1200-1000°C; +AT - Solution annealing (air or water cooling): 1150-1200°C.
ASME X1CrNiMoCuN24-22-8 Mechanical Properties
Temperature
Need complete mechanical properties to make the right choice?
Get complete data on strength, hardness, fatigue, and more.
Free registration required • Instant access
ASME X1CrNiMoCuN24-22-8 International Equivalent Materials
Showing 15 of 75 results.
Equivalence categories reflect chemical-composition and mechanical-property comparison — always verify suitability against the governing specification for your application.
Need the full list of 75 international equivalents?
See all 75 equivalent grades with detailed mapping by standard, producer and equivalence category.
Free registration required • Instant access
Optimize material selection for your application - Book A Demo
- 75Cross References
- 20Composition
- 62Mechanical Properties
- 3Physical Properties
- 2Heat Treatment
- -Metallography
- -Machinability
- -Stress-Strain
- -Formability
- -Fatigue
- -Fracture
- -Creep
- -Joints
- -Coatings
- -Dimensions
- -Tribology
- -Corrosion
- -Ageing
- -Weatherability
- -Irradiation
- 42Total Suppliers